help with problem please

[JAZZCNC]

Yer & cheap Chinese drivers as well, he bought 3 drivers & a bob, wired it all up & the x axis driver blew up, seller told him to try again & he blew up another driver lol, was asked for pictures to ensure all was wired correctly & after sending the pictures was sent a complete new set of drivers & bob, still no joy so seller sent another bob

Ok Well sounds like he needs to take the Hint and buy some decent gear.! . . . . . Bet there the TB based drives as well.?

That said Because 2 drives are going off at same time I'd be inclind to think it's the BOB not the drives but swapping the good working axis drive will show up if it's the drive or BOB.?

Not something I'd recommend unless the person is confident with electrics is to by pass the BOB all together and wire direct from the PP pins but this is a risky move and could blow the PP if not done correctly. So only for the competent hacker really.!