Small rigid router - Design advise needed

[TonyD]

Mitchejc, its totally feasible just take your time.
When I started I looked into the electrical before the mechanicals (which was a mistake) and I think in the end had I not stopped I'd have had 3 iterations of my control box, the first one had no safety and Jazz and Andy intervened to help.

I would start with power, get the PSU's in and working, then get the safety system arranged to kill the power as needed with the combination of limits and estops. Then I'd go for the bob and make sure that the safety circuitry can send the right signals to that. From there I'd work on home and limits to the bob and then you've got the guts of a working control system, motors and drivers are usually a function of the right wires in the right place, not much scope for creativity or screwing that up, maybe there's some motor tuning via drivers but that’s icing once the rest is done, not saying its not important, just most likely done near the end.

The critical thing in IMO right now is figure out the safety and control (limits and home), there's lots of good advice on the forum, limits NC, estop the same etc.. Personally I found it challenging to get into all the relays and drew comfort from the reliability of the pilz, they are available second hard and if you can get one I don’t think you'll regret it. Even starting out with some power and a pilz with a reset button and the estop circuit will build your confidence a lot.

Lots of folks have great advice, some of it is a bit overwhelming when you're a beginner, I'd proceed as outlined and add the frills like spindle control, water pump, etc once you’ve got power, safety and comms to the PC via the bob sorted.

Ps. I needed a bigger box each time I added a new feature, either get one bigger than you need or figure out the basics without a box first.