:-)

No, its just 1:1 ratio. My understanding is that belt drive will make the machine a little smoother. X and Y would be possible to do direct drive but Z will be difficult as I'm trying to keep it as flat as possible.

Not sure but I'm thinking of welding on tabs or a piece of flat bar on both sides that will allow me to bolt it to the table.


Quote Originally Posted by Blackrat View Post
ja ja wat se jy :P

why even go with belts ? are you going to have a step down ratio ?

i wouldnt bother with the 3rd rail, i think it will just make it harder to clock up ...

what or how are the two bottom rectangle tubes fastened ?

looking good :D