my 6040 experience (yeah, and problems) so far

[jimbo_cnc]

The good driver is happy running the long axis at 4000mm/min & 400mm/s2 (twice the standard) on its own. The fault occurs even with all axes at 1/2 standard speed.

What's a half decent PSU/BOB/3x drives gonna cost me? If the seller can't replace quickly or the next ione is also faulty I'll be after a discount towards my replacement controller box.

[EddyCurrent]

I may be wrong but I think these are the main UK suppliers of stuff used by DIY'ers, plus obviously there's ebay.

http://www.diycnc.co.uk/
http://www.zappautomation.co.uk/
http://cnc4you.co.uk/

If I was in your position I woud change the breakout board first and would most likely choose a similar board from ebay, they are less than a tenner from abroad, in fact I have just realised I have a board like yours that I bought to get extra inputs to my system, it's working fine in that role. It connects into port2 of my SmoothStepper

[JAZZCNC]

I would go for the part refund and buy decent electronics with a mind to transplant to your next machine. . . . No point replacing crap with crap.!!

To be honest I'd want more than just the refund of the Drive and BOB there's your fiddling time and Down time to take into acount.
These things need to be accounted for when your thinking about electronics and machine because what's the point having a machine if your spending more time chasing faults or fixing the bloody thing or than using it.?

[amxen]

just found out what my problem is. made my own post

http://www.mycncuk.com/threads/7839-...1165#post61165

dont know if it will help any one

[jimbo_cnc]

Bit more info. summary: Mistakes corrected, but no happy ending.

When adjusting dip switches, refer to the instructions on the side of the driver, not to an instruction for a different driver that you found on the internet! Yes folks, I don't have leadshine M542s, I have Tongka M542s and the dip switch setting are different.

Funny thing is that when I looked at the dips I found a setting that indicated 16 microsteps, unfortunately that was just chance. So when I thought I was changing from 16steps to 8steps, I was actually changing from 3A to 2A, and from 0% decay to 50% (whatever that is).

I've put everything to how it was set originally. And I've tried 8steps instead of 16. In both cases all the faults are just the same as before.


I did spot that dip7 is set at 1/2 current. The other option is full current. Looks like I'm running at half throttle ?

[JAZZCNC]

I did spot that dip7 is set at 1/2 current. The other option is full current. Looks like I'm running at half throttle ?

This is to drop the current when motor is at stand still to reduce over heating keep it set.

Edit: Opp's sorry irving didn't see you'd replyed already.!

[jimbo_cnc]

Seller responded just in time (I was openeing a case as the message came in). He says no controller boxes in UK but will send me 2x driver controllers. I said I also want interface board, even if it ships from china.

I could do some cutting using manual control for Z, as that wouldn't trigger the problem. but I will wait and get on with other stuff until spares arrive. Signing out for a few days :(