my 6040 experience (yeah, and problems) so far

[JAZZCNC]

Don't get me wrong here Jim but this is what I'm meaning with these machines you'll be constantly chasing this sort of thing and with every hour of cut time it will just get worse due to wear and with more to chase until eventually you'll get sick of it.

I see this time and time again, at the minute your fresh to it and enjoying what your getting off the machine but this will change as your imagination runs riot and Cam/Cad abilty's increase.! This is when the machine will drive you up the frigging wall as it will hold you back and frustrate the hell out of you.
IMO . . . IF you have the option to bail out now and get most of your money back then I'd grab it and put it down to learning and be thankful it didn't cost anything but lost time.!! . . . . . . If not it will cost you and will frustrate you sooner rather than later.