-
25-07-2014 #1
I am at the stage in my build were i am at my weakest point. I have all the electronics wired up with a lot of help from a friend however they or myself do not have much knowledge when it comes to setting up the computer up and getting the two things connected I have Mach3 demo on the computer and the plug in for the csimo M sorted i belive. I think i have changed the ip address as well but im struggling to get the two things connected. I was just wondering if there was anyone in the sussex area that may be able to lend a hand in showing me how to set the basics up.
Best regards
Charlie
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
NEW MEMBER: Hello from Sussex
By Pointy in forum New Member IntroductionsReplies: 5Last Post: 16-12-2013, 11:13 PM -
Tool Height Setting Probe - Mach3 - solution
By HiltonSteve in forum Tool & Tooling TechnologyReplies: 18Last Post: 12-11-2013, 06:23 PM -
NEW MEMBER: Hello from Sussex
By Woobis in forum New Member IntroductionsReplies: 1Last Post: 09-11-2010, 11:09 PM -
Mach3 limit setting and G-code creation
By HUKBMBEAR in forum Artsoft Mach (3 & 4)Replies: 8Last Post: 26-08-2010, 04:42 PM -
NEW MEMBER: Hello From Sussex.
By Phil Gravett in forum New Member IntroductionsReplies: 8Last Post: 22-05-2009, 12:00 PM
Bookmarks