1st time setting up.. whats normal..

[Clive S]

I have been looking in more detail at my config and feel I have some conflicts. I would be grateful if you (anyone..) could look them over and see any obvious problems..

It looks like you have pin 16 configured twice which won't help (you can only have one pin configured once only for each port).
Are you using two motors on one axis if so have you configured slaving in Mach. ..Clive

[Marlin]

I intended to slave 2 motors together on the Y axis but on the board that channel appears Duff (to the best of my checking ability) so, No I haven't knowingly done any slaving.
Are you running Mach3?

[Clive S]

I intended to slave 2 motors together on the Y axis but on the board that channel appears Duff (to the best of my checking ability) so, No I haven't knowingly done any slaving.
Are you running Mach3?

Well I am not sure what you are trying to achieve. i.e. try and get 3 motors working first x,y,z and do things logically, don't keep jumping around. You have not said if you have sorted pin 16 out.
Yes I do run Mach3 and linuxcnc not sure why you want to know though.

I suggest you ask one question at a time and stick to the point. Sorry if this is harsh but there is no point in writing a novel. ..Clive