Initial workpeice tooling set-up instructions using a pendant controller type machine

[Clive S]

By default V carve sets the material z position to the bottom of the job. Did you change it to the top?
Also did you have the "model in material" set to "gap above model". .. Clive

[Nthkentman]

By default V carve sets the material z position to the bottom of the job. Did you change it to the top? Clive

Hi Clive, yes I did change it to the top. The diagram shows as you say the default at the bottom of the workpiece, (Which I also tried) but irrespective of how I set it the Z axis is wrong... I'm wondering now if I am sending the wrong G code to the machine.
The PP asks for a file with extension .nc
So I use the first available .nc choice as my machine is not listed.
Perhaps I'm doing that wrong ?

[Clive S]

Well if you want to be sure have a look at the gcode it produced you can open the file by renaming it to .txt ..Clive

[Nthkentman]

Thanks Clive, I may try that and post the results here. I'm fairly new to G code, as when I were t'prentice the programming and such was done by the clever office bods :-)

How would I detect if the code is wrong please?

[Clive S]

If you post the top 20 line of code it should be easy to see. you just look for the g1 z!!! parts. Did you re read my edited post lower down for the position of the model in material. ..Clive

[Nthkentman]

I'll got to my machine tomorrow and get the file. I'm not sure what you mean about the position of the model in the material though. Sorry if this seems a bit dumb, but I did think I could remember more ... Maybe not

[Clive S]

On my version its on the right hand side under Toolpath operations (setup material and rapid gaps) set your Z to the top and Gap above model to zero. ..Clive