Initial workpeice tooling set-up instructions using a pendant controller type machine

[Nthkentman]

Hi Silyavski,

My PP file extension needs to be .nc according to the instructions. Not sure if it will accept metric .txt, but I may try.
I'm setting the machine toolpath in "Profile Toolpath"...Do you think I should be using the "Pocket toolpath" instead ? The setings in your picture are the same as the ones I my program too,
My intention is to cut 4mm MDF/Ply on a sacrificial backing board to allow the cutouts to be used/pushed out then finished after for sale... Items like hearts, stars, letters and numbers etc