Initial workpeice tooling set-up instructions using a pendant controller type machine

[Nthkentman]

Hi Silyavski,

My PP file extension needs to be .nc according to the instructions. Not sure if it will accept metric .txt, but I may try.
I'm setting the machine toolpath in "Profile Toolpath"...Do you think I should be using the "Pocket toolpath" instead ? The setings in your picture are the same as the ones I my program too,
My intention is to cut 4mm MDF/Ply on a sacrificial backing board to allow the cutouts to be used/pushed out then finished after for sale... Items like hearts, stars, letters and numbers etc

[Boyan Silyavski]

Sorry , i though you use mach3. Though you can just rename the file.

There are places that profile is used, there are places where pocket is better, to avoid triangualr and similar small left overs. Though it could take a bit longer.