Thread: Glue for Vacuum Press Veneer?
Threaded View
-
03-09-2014 #9
Hi Tenson
If you look @ my setup you will see that the veneers are covered in a blue material, this is a plastic mesh that i use for doing vacuum infusion jobs, if you go to any online dealer that sells infusion resin you will find some there, the white tubing is spiral wrap. cheapest place to get this is Maplin(or it was when i bought mine) it's used for holding loose wires to tidy them up.
If you notice you will see the glue extruded through the joints between the veneers. This was a trial run to see if i could make a half decent job of it as i intend to do all my sills the same (the windows are Iroko also)
Hope that helps and good luck with your next shot.
Mike
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
WANTED: Drill press
By D-man in forum Items WantedReplies: 0Last Post: 30-08-2013, 07:45 AM -
RFQ: Press cost question ?
By Fivetide in forum Projects, Jobs & RequestsReplies: 8Last Post: 01-12-2012, 08:26 AM -
Bearing interference fit / press fit
By Mad Professor in forum General DiscussionReplies: 5Last Post: 30-09-2012, 11:26 PM -
RFQ: small, primitive Press with cutting and bending capability
By Noel.C in forum Projects, Jobs & RequestsReplies: 15Last Post: 29-05-2012, 11:37 PM -
Workpiece hold down by glue
By Robin Hewitt in forum Machine DiscussionReplies: 2Last Post: 30-09-2010, 08:22 PM
Bookmarks