Thread: On going chinese 6040 problems
Threaded View
-
08-09-2014 #10
Hi Clive. I know the kit I have is not amazing but it's all I could aford at this time. I'm not too worried about my set up as I have it running ok tbh, just not at the seeds they say it will run.
At the moment I have it set like this 320 - 1000-100. And it runs ok just a bit slow. This is fine for now as I'm just learning. But if I try any higher like say 320-1200-150 then it starts to randomly jam. At 320-1500-200 or higher it will jam all the time. I'm guessing the recommend setting are a sales lie by the eBay seller and not what the electronics are up to.
But I would like to track the fault down so I don't junk what I don't have to when I want it to run faster.
I'M thankful for all and any help I get on here.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
New 6040 owner looking for advice from others with a chinese 6040/3040
By itsmillertime in forum Machine DiscussionReplies: 12Last Post: 14-10-2019, 08:30 AM -
Chineese 6040 problems
By Kendrick57 in forum Gantry/Router Machines & BuildingReplies: 18Last Post: 18-10-2015, 10:52 PM -
Chinese 6040 from uk eBay seller x axis problem
By CommanderKenyon in forum Gantry/Router Machines & BuildingReplies: 4Last Post: 20-02-2015, 02:13 AM -
my 6040 experience (yeah, and problems) so far
By jimbo_cnc in forum Machine DiscussionReplies: 52Last Post: 07-10-2014, 11:26 AM -
Chinese 6040 CNC Router Advise Needed
By Bob Hepple in forum Chinese MachinesReplies: 24Last Post: 27-11-2013, 12:00 PM
Bookmarks