-
10-09-2014 #1
Hello, new member here hoping for a recommendation for somewhere in North London that could very accurately cut and rebate five holes for loudspeaker drivers in two sheets of 18mm or 25mm MDF. Examples of three of the cutouts are attached. The fourth speaker will be substantially similar to the third one below (T27) - i.e. less complex than either the B139 or the B110 and the final hole is an oblong measuring 3" x 10".
Any help would be most appreciated.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Spindle Motor Recommendation.
By cambesol in forum Marketplace DiscussionReplies: 0Last Post: 21-11-2013, 12:15 PM -
Router recommendation for University
By S2L in forum Marketplace DiscussionReplies: 12Last Post: 05-12-2012, 11:58 AM -
Router bit recommendation, spindle speed and feed rate?
By FlightCaseCo in forum Spindles & Drive MotorsReplies: 13Last Post: 03-04-2012, 12:53 PM -
NEW MEMBER: Hello from up north
By swarf-boy in forum New Member IntroductionsReplies: 2Last Post: 04-09-2010, 11:53 PM -
NEW MEMBER: Hello from the North!
By fozziebear40 in forum New Member IntroductionsReplies: 2Last Post: 29-04-2009, 09:41 AM
Bookmarks