Router/Plasma CNC Build From Down Under

[EddyCurrent]

Sounds like you've done a good research job, I think 20mm ball screws may be in order and if you use good digital drivers for the stepper motors then speed should be achievable.
There's not much to say until the pictures are up.

[Tinkerer]

Thanks Eddy. I have very much enjoyed reading and learning from your contributions to this site. For some reason I cannot load dwg files, so have reverted to pdf format. Attached are images and Excel spreadsheet of materials:





Materials and Mass 20140930.xls

I look forward to your and other's feedback.

[Tinkerer]

I have been asked to upload JPEG files. Here they are (slightly different perspectives but from same drawing). If someone can advise what the preferred file format for graphic uploads is, then I will stick with that going forward.