Router/Plasma CNC Build From Down Under

[TonyD]

One consideration I fell fowl of was that I was also constrained on space, so as I order plywood for a project now I need it cut at supply. If I were doing it again and could have made the space I'd have gone for a design that could take a standard 8x4 sheet of wood straight from supply.

[Tinkerer]

Hi Tony, thanks for the feedback. I have grappled with the same issue, but I believe I can source plywood at the smaller lengths here (or get the saw out!). Even if this were not possible, the space availability is an issue, so I will err on the small side for now...perhaps for the next build!