power supply

[Lee Roberts]

Lee. . . . Think this seller should be put(linked) some where others can find him as well, seems ok to me!!!

No problem mate your welcome to submit your findings in the FAQ section/forum for others. I think diycnc.co.uk also sell these kinds of psu's.

[Swarfing]

Hi guys

I have the 5 axis version and did a lot of checking on this board before i bought it. There is no need for a separate supply as it takes the 5v from the main input. i am using 3 x 24v at 4.2 amp switch mode supplies i bought off Ebay in parallel (£7.99 each plus p&p). These have voltage adjusters on board so i could set them up before plugging them together. I found that by looking at how they show you to set it up in Mach 3 was the best indication for translating the manual. I hve only plugged 1 stepper in so far just to check it worked with EMC2 and it is fine.

Thanks

Paul