Hi guys

I have the 5 axis version and did a lot of checking on this board before i bought it. There is no need for a separate supply as it takes the 5v from the main input. i am using 3 x 24v at 4.2 amp switch mode supplies i bought off Ebay in parallel (£7.99 each plus p&p). These have voltage adjusters on board so i could set them up before plugging them together. I found that by looking at how they show you to set it up in Mach 3 was the best indication for translating the manual. I hve only plugged 1 stepper in so far just to check it worked with EMC2 and it is fine.

Thanks

Paul