Quote Originally Posted by mekanik View Post
I run a small lathe Elliot Emcomat 7 and have allways found i can get the job better secured with the 4 jaw, parting even if it isn't deep will give you a better reference for sawing the blanks of(unless your sawing is better than mine)
Discusion i8s finished as far as i am concerned, and out of interest i used to work as a centre lathe turner.
You gave your advise based on your experience, i have mine based on mine. Asked what was the point in putting a 4 jaw on, i value time and could see no benefits of fitting a 4 jaw then swopping out to 3.
End of