Threaded View
-
11-10-2014 #1
HI I am a bit wary of posting as I have seen some of the replies on other threads lol.
However I need to get my small CNC engraver working.
When I purchased it second hand it was supposed to have a part missing. Allegedly a power supply but it does seem to have one.
I know its a parallel interface and my computers dont have parallel ports anymore. so I am going to take a photo or two and see if you can assist. bear in mind I only really want it for two things. one to learn how to program and use CNC a bit and 2. To use it on its end to raise and lower a platform about 6 inches or so with a degree of precision.
I forgot to ask where can I get spare parts for these things and can any one tell from the photos what parts are missing. Please bear in mind the controller board is there but I wish to use USB so will need a new board..
regards Andy TLast edited by ukracer; 12-10-2014 at 12:41 AM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
FOR SALE: power supply
By Web Goblin in forum Items For SaleReplies: 0Last Post: 14-09-2014, 03:19 PM -
Power Supply Questions and Advice Needed
By timellis in forum General ElectronicsReplies: 16Last Post: 11-09-2013, 09:32 PM -
Minimal-cost Power Supply Strategy - Repurpose Laptop Power Supplies
By LoveLearn in forum General ElectronicsReplies: 0Last Post: 25-01-2012, 09:29 PM -
FOR SALE: 50V 20A Power supply
By Jimmybristol in forum Items For SaleReplies: 8Last Post: 30-05-2011, 11:01 PM -
power supply
By hitmythumb in forum General ElectronicsReplies: 6Last Post: 21-06-2009, 10:27 AM
Bookmarks