. .
  1. #1
    I am about to configure a "System 45" 3 axis unit by DIYCNC in the UK , can some one please advice on what timing setting I should use when using the StepConf Wizard in LunuxCNC.
    Also the instructions for the System 45 give the following setting for the drivers that I don't understand?

    1/2 step type B (0-100%)
    1/2 step type A (0-71-100%)

    Which should I use?

    Thanks

    Steve

  2. #2
    Best bet is to email Roy, be patient for a reply though
    Have you tried the default values for timing ? also do you really want 1/2 stepping ? it obviously depends upon the application but most go with 1/8 , in which case you dont care what (1/2 step type B (0-100%)
    1/2 step type A (0-71-100%)) means.
    Last edited by EddyCurrent; 15-10-2014 at 02:00 PM.
    Spelling mistakes are not intentional, I only seem to see them some time after I've posted

  3. #3
    Thanks for that I will give that a try, at the moment I am trying to get the parallel port address sorted!!!!

    Steve

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. "Hacking" and "Modding"
    By magicniner in forum General Discussion
    Replies: 15
    Last Post: 07-01-2015, 08:59 PM
  2. CNC machine "Spanish" model . Advice and opinions needed!
    By shapebusters in forum Machine Discussion
    Replies: 17
    Last Post: 12-03-2014, 06:21 AM
  3. Replies: 4
    Last Post: 28-09-2012, 12:06 PM
  4. "Racks" VS "ball screw"
    By C.AlveSilva in forum Linear & Rotary Motion
    Replies: 1
    Last Post: 17-04-2012, 11:53 PM
  5. Replies: 1
    Last Post: 25-12-2010, 06:05 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •