Setting up "System 45" 3 axis unit by DIYCNC

[StevenT]

I am about to configure a "System 45" 3 axis unit by DIYCNC in the UK , can some one please advice on what timing setting I should use when using the StepConf Wizard in LunuxCNC.
Also the instructions for the System 45 give the following setting for the drivers that I don't understand?

1/2 step type B (0-100%)
1/2 step type A (0-71-100%)

Which should I use?

Thanks

Steve

[EddyCurrent]

Best bet is to email Roy, be patient for a reply though
Have you tried the default values for timing ? also do you really want 1/2 stepping ? it obviously depends upon the application but most go with 1/8 , in which case you dont care what (1/2 step type B (0-100%)
1/2 step type A (0-71-100%)) means.

[StevenT]

Thanks for that I will give that a try, at the moment I am trying to get the parallel port address sorted!!!!

Steve