Boxford software

[Gasgasbones]

Hi all

I hope someone here can help !

I bought a Boxford 190 VMC and was working well on the old software (DOS) that it came with, its the dead old floppy discs.
For whatever reason I set the config to defaults as I thought it would give me a fresh start with tools settings etc.

Now it wont let me configure the machine/software and I get these error messages.

'Normal users cannot change these settings' and 'Configuration set to no machine connected'

Its doing me in ! ive only had th machine a couple of days and after a couple of successful cuts its now Kapput !

Can anyone help please ?

Thank you

Carl

[Gasgasbones]

No One ??

I think the software is set like that to stop students from making changes that they shouldnt. I need a MS DOS expert to guide me to make the right changes so that I can configure the machine.

As I mentioned before, the thing was working fine till I hit the set to default !!! arrrgghh. why !!

Anyone, please. dying to get going here

Thank you

Carl

Hi all

I hope someone here can help !

I bought a Boxford 190 VMC and was working well on the old software (DOS) that it came with, its the dead old floppy discs.
For whatever reason I set the config to defaults as I thought it would give me a fresh start with tools settings etc.

Now it wont let me configure the machine/software and I get these error messages.

'Normal users cannot change these settings' and 'Configuration set to no machine connected'

Its doing me in ! ive only had th machine a couple of days and after a couple of successful cuts its now Kapput !

Can anyone help please ?

Thank you

Carl

[EddyCurrent]

Have you enquired here ?

http://www.boxford.co.uk/spares/
http://www.boxford.co.uk/software/software-updates/

[Gasgasbones]

Yes, I emailed them but have had no response as yet.

Have you enquired here ?

http://www.boxford.co.uk/spares/
http://www.boxford.co.uk/software/software-updates/

[EddyCurrent]

This ?

https://www.scribd.com/doc/132758792/CNC-Milling

This ?

http://tturkyilmaz.home.anadolu.edu....kz/millcam.pdf


These people ?

http://store.lathes.co.uk/boxford

[JDS]

I have the windows version of the software and you need to be using the software at "Administrator" level to get at and change the setup and calibration. The user level can be set into Admin mode by settings/user/administrator.

I have the e-manual for the windows software if you need it.

Jon