Wiring a motor - as a newbie!

[EddyCurrent]

A+ yellow/white & red
A- yellow & red/white
B+ green/white & black
B- green & black/white

see diagram on page 7 for parallel 8 wire connection

http://www.leadshine.com/UploadFile/Down/AM882m.pdf

[D-man]

cheers does it matter if its not a Leadshine?

[EddyCurrent]

No, it was just a diagram I knew about, it's the motor drawing that matters.

[D-man]

OK guys another one im needing help with... i have another SY60STH86/3008BF - however the wire colours are different but on zapps website datasheet

The wires on my motor are as follows

red
blue
black
green
blue/white
black/white
red/white
green/white

sure this is just done to confuse the hell out of me haha

[D-man]

OK so maybe not so bad as i thought.. only the Blue & Blue/White is different. will call this the "Yellow" wire :)

So is this correct:

A+ yellow/white & yellow (but its blue!)
A- Red/White & Red
B+ Green/White & Green
B- Black/White & Black

[EddyCurrent]

Using the standard diagram;



For any colour scheme with parallel connections use this; (I've just used -A etc. to represent A with a bar on top (not A))

A+ (A to -C )
A- (-A to C )
B+ (B to -D)
B- (-B to D)

[D-man]

Nice one buddy thanks

[charlieuk]

Using the standard diagram;



For any colour scheme with parallel connections use this; (I've just used -A etc. to represent A with a bar on top (not A))

A+ (A to -C )
A- (-A to C )
B+ (B to -D)
B- (-B to D)

Im really struggling to get this around my head, i think i have read it so many times i have confused myself (i need to swap from series to parallel as i didn't realise first time round)

which pairs do i join to each other and which pairs to i wire to the terminals?

many thanks

[EddyCurrent]

Using the diagram above

Parallel

A+ (Yellow/White to Red)
A- (Yellow to Red/White)
B+ (Green/White to Black)
B- (Green to Black/White)

Series

A+ (Yellow/White)
A- (Red/White)
B+ (Green/White)
B- (Black/White)

(Yellow to Red) not connected to any terminal, just connect together and insulate.
(Green to Black)not connected to any terminal, just connect together and insulate.

[charlieuk]

Ok so when in parallel you pair the 8 wires (4pairs)accordingly and then they would go strait to the terminals on the driver were as in series you just have 4 of them paired (2pairs) and the other 4 go to the driver?
Many thanks