Auto Square the gantry

[D-man]

Hi Gerry,

Really? are the ones in the picture only for Limit switches?

I have unchecked "Home slave with master"

That remionds me, is there a way to recover my screenset from you. i bought it a while back and since lost and upgraded my pc.

[Ger21]

I thought you were referring to input 1 in Mach3, not on your board.

Does it work with "Home Slave with Master" unchecked?

Send me an email and I'll resend the screenset to you.

[EddyCurrent]

Are the home switches normally open (NO) or normally closed (NC) ?
If NC you wire the X,Y,Z in series then into one input of the bob, then A (the slaved X) into another input of the bob
If NO you wire them in parrallel then into one input of the bob, then A (the slaved X) into another input of the bob

You can see how my NO inductive proximity switches are connected here (bottom left corner);
http://www.mycncuk.com/threads/6565-...7622#post57622

[D-man]

Thanks Gerry, would you like me to send it from the one i would of used with Paypal to prove i have purchased it?

Yeah the motors all work as they should. its only when it comes to homing and that home switch not being active or whatever reason

[D-man]

oh i didnt go that far buddy... i just put each one on their own input in the bob.

i dont understand it every other switch works bar this one on the A axis