Twin ball screw drive on X - configuration question

[Smiler]

Drew a part up the other day and sorted a long thin bit of spare material out it would just fit on and put it on the router with a lump sticking out.

Loaded the program and realised I had drawn it 90 degrees to how the material lay so X needed to be Y and visa versa.

Went into Mach and swapped the pins over in ports and pins, cut the job and then swapped it back.

Any chance of a photo of some of your machines John, you seem to do such a wide range of work with them. Are thay all self made?

Jeff.