Advice on spindle/drill bits for a beginner

[cropwell]

Kress goes straight in to mains.

[JAZZCNC]

Don't over tighten the Kress in the spindle mount otherwise you'll kill the bearings.!!
Lightly Nip up in the mount then start the spindle(without cutter) and then start tightening while listening. If it starts changing tone your over tightening.!

Mostly I consider the Kress a Toy but for this machine then agree with eddy it's overkill so will be ok.

[Skydeals]

yes i thought it might be. reason i bought that one was so i could remove it and put it on a larger table i hope to build later on, and sell on the basic 540. spindle is arriving tomorrow so i will listen out while tightining mount. thanks jazzcnc