. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 26-11-2014 #22
    JAZZCNC's Avatar
    Lives in wakefield, United Kingdom.
    JAZZCNC
    Last Activity: 19-01-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 8,446. Received thanks 1,445 times, giving thanks to others 109 times.
    Quote Originally Posted by Gotty101 View Post
    JazzCnc are inductive proximity switches accurate enough to use as home and limit switches? Ive used magnetic hall probes in the past but never there.
    Yes they are very accurate see the vid I made.



    Quote Originally Posted by Gotty101 View Post
    Also would 3mm plate be strong enough for my cutting bed box with a 10mm drilled mounting plate installed in the bottom or shoul I make the box out of 5mm sheet?
    Well if it's just box to contain coolant then yes will be fine but if your thinking to mount cutting bed in there and hang like the drawing suggests then NO WAY will it be strong enough.
    To be honest when I first seen the drawing I wondered if you had in mind to put the cutting bed in the bottom of that box and dismissed it that you wouldn't be doing that but now I'm not so sure.! . . . . So which is it.?
    Reply With Quote Reply With Quote

  2. The Following 2 Users Say Thank You to JAZZCNC For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Initial workpeice tooling set-up instructions using a pendant controller type machine
    By Nthkentman in forum Machine Discussion
    Replies: 25
    Last Post: 30-08-2014, 08:33 PM
  2. Component Check
    By manofgresley in forum General Electronics
    Replies: 1
    Last Post: 22-04-2014, 06:04 PM
  3. Initial thoughts on new build
    By Neale in forum Gantry/Router Machines & Building
    Replies: 4
    Last Post: 25-01-2014, 11:05 PM
  4. Some initial questions....
    By andy586 in forum Gantry/Router Machines & Building
    Replies: 5
    Last Post: 27-01-2013, 03:00 PM
  5. Newbie Initial Wiring/Setup
    By Rikk in forum Motor Drivers & Controllers
    Replies: 3
    Last Post: 28-06-2011, 10:19 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules