. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 09-09-2015 #19
    Gotty101's Avatar
    Lives in Lichfield, United Kingdom.
    Gotty101
    Last Activity: 08-10-2019 Has been a member for 9-10 years. Has a total post count of 73. Received thanks 2 times, giving thanks to others 9 times.
    Hi guys, ive still working on the build and doing all the wiring when i can, but i could do with some setup advice.

    Im using AM882 drives and the following 4nm steppers (http://www.cnc4you.co.uk/Nema23-Step...m-60BYGH401-03)
    I would like to know any general settings to make in the ProTuner software for the drives, as ill be configuring the alarm port setting so its always on and off in the event of a fault so i can daisy chain the alarms, and it will trigger a stop should a fuse go or a wire brake.

    One question is i know its bad to unplug the motor from the drive while its running, but would it be bad to power the drive up with no stepper connected for setup purposes of the alarm circuit ect?

    Many Thanks

    Trev
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to Gotty101 For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 2 users browsing this thread. (0 members and 2 guests)

Similar Threads

  1. Initial workpeice tooling set-up instructions using a pendant controller type machine
    By Nthkentman in forum Machine Discussion
    Replies: 25
    Last Post: 30-08-2014, 08:33 PM
  2. Component Check
    By manofgresley in forum General Electronics
    Replies: 1
    Last Post: 22-04-2014, 06:04 PM
  3. Initial thoughts on new build
    By Neale in forum Gantry/Router Machines & Building
    Replies: 4
    Last Post: 25-01-2014, 11:05 PM
  4. Some initial questions....
    By andy586 in forum Gantry/Router Machines & Building
    Replies: 5
    Last Post: 27-01-2013, 03:00 PM
  5. Newbie Initial Wiring/Setup
    By Rikk in forum Motor Drivers & Controllers
    Replies: 3
    Last Post: 28-06-2011, 10:19 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules