. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 26-10-2014 #1
    EddyCurrent's Avatar
    Lives in West Cumbria, United Kingdom.
    EddyCurrent
    Last Activity: 02-10-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 2,197. Received thanks 276 times, giving thanks to others 110 times. Is a beta tester for Machinists Network features.
    I would advise against the 15 size, the bearing blocks are an absolute pain to grease, go with 20's all round.
    Last edited by EddyCurrent; 26-10-2014 at 10:54 AM.
    Spelling mistakes are not intentional, I only seem to see them some time after I've posted
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Initial workpeice tooling set-up instructions using a pendant controller type machine
    By Nthkentman in forum Machine Discussion
    Replies: 25
    Last Post: 30-08-2014, 08:33 PM
  2. Component Check
    By manofgresley in forum General Electronics
    Replies: 1
    Last Post: 22-04-2014, 06:04 PM
  3. Initial thoughts on new build
    By Neale in forum Gantry/Router Machines & Building
    Replies: 4
    Last Post: 25-01-2014, 11:05 PM
  4. Some initial questions....
    By andy586 in forum Gantry/Router Machines & Building
    Replies: 5
    Last Post: 27-01-2013, 03:00 PM
  5. Newbie Initial Wiring/Setup
    By Rikk in forum Motor Drivers & Controllers
    Replies: 3
    Last Post: 28-06-2011, 10:19 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules