Initial Design Check Please

[JAZZCNC]

Doesn't need anything too fancy Just make a strong frame which fastens to main frame and sit bed on it then surround bed with sealed sides and it won't be any issue but just hanging the bed inside the box will make it resonate and vibrate like crazy when cutting.

Would also use thicker than 10mm Ali for the bed 15/16mm minimum 20/25 better.

[Gotty101]

Thanks Jazz, ive just redrawn the lower frame and the bed but just need to finish a few bits before i post any more pics up. Ive ordered the prox sensors.

Thanks

Trev

[Gotty101]

Hi Jazz, ive redrawn the bed its now 20mm thick with a box thats 25x50 surrounding it.

[JAZZCNC]

Better but will be difficult to achieve and be good enough. Far simpler to just make box section frame and sit the Bed on top then just use Thin sheet to make a surround for containing coolant.
Also how you going to drain and filter and remove coolant/chips because that box will soon fill up with chips/coolant.?

[Gotty101]

Hi Jazz, thanks for the reply. Ive altered it and hopefully im getting there. I am planning on using thin aluminium angle to build up a shallow surround. Im planning on using mist cooling and not flood.



With regards to electronics what kind of steppers do you think this cnc will eventually require would it need the 3.1nm or 4nm stepper, only reason im asking is to check the stepper space that ive got for the z axis stepper?
http://www.cnc4you.co.uk/CNC-Kits/Di...3.1Nm-x-3-Axis

[Gotty101]

Hi Jazz, does that look ok, the t slot plate will be bolted directly to the adjustable steel frame. Then gutters can be added to the steel frame if im going to be running coolant or not, these will be just aluminium angle.

[JAZZCNC]

Hi Jazz, does that look ok, the t slot plate will be bolted directly to the adjustable steel frame. Then gutters can be added to the steel frame if im going to be running coolant or not, these will be just aluminium angle.

Yes but personally I'd have the rectangle cross pieces vertical so they provide more strength against deflection. Have a Flat base frame then sit Aluminium onto it then just make thin sheet surround which fastens into sides of ali plate.