Machine Feet for my lathe

[cropwell]

Hi Jim,
I have the Amadeal 290V-FF, which is a similar weight to yours. The cabinets are substantial but the tray is only .8mm steel. I am currently modifying the tray to put a drain slope in it for the coolant. When I installed the machine I put down a ply frame round each cabinet and set the frame tops level as I could. Then removed the cabinets and filled the frames with self levelling compound (add a bit more PVA to the mix). The cabinets are rag-bolted to the floor. The tray is being modded by putting a 25mm platform under the bed at each end. I need to raise the bed from the chip tray to give me space to clean out swarf. When I put it all back together I will check the shimming.

I would like the whole machine to be lower as I have to sit to work. I can't stand for long due to arthritis, but I suppose the answer is a higher chair.

Cheers,

Rob