Vcarve workpiece orientation

[EddyCurrent]

Maybe part of the answer lies here; http://www.mycncuk.com/threads/8004-...ight=backwards
D-man, how did this conclude ?

[D-man]

As Gerry mentioned i reversed ports and pins, however the workpiece is now inverted and im getting narrow letter (test) also when doing to i get rounded corners, not sharp ones

[D-man]

ok so ive managed to get the T the right way up to where i want it.

will i have to do the steps per again due to swapping the axis, and also with the T being very narrow

[firetrappe]

Looks like your motor tuning calibration needs swapping over too. I'm guessing you've got different pitch screws on your x and y?

That should sort out the narrow letter problem.

Edit : Check your cursor keys for jogging from the keyboard too (hotkeys). You'll probably need to change those too.

Si.

[D-man]

Awesome, im running rack and pinion on both axis. however one is on a gearbox and other two on cncrouterparts drive pulleys

[Ger21]

You shouldn't need to change your jogging hotkeys, unless you've already changed them to a non standard configuration.
You will need to change your steps/unit, and accel and velocity settings if they are different for X and Y.

[D-man]

Thanks guys i now have it the way i wanted it :)