Threaded View
-
01-11-2014 #21
Sorry, I stepped out for a bit.
I will reset to default values and do another video for you Gerry with screen included
What is your Safe Z set to? Is it set to Machine Coordinates?
Third attempt, works great with a 5.3 offset and same settings as above. go to zero and it just kisses the work piece
Leave the Material Offset unchecked until you get it to zero reliably without plunging. This just adds more complexity to the equation.
Second attempt, with clearance set to 20mm Goes up! but plunges too far when set to top of work piece.
After probing, the macro sens a single G0 Z move to the clearance plane, which should be UP.Gerry
______________________________________________
UCCNC 2022 Screenset
Mach3 2010 Screenset
JointCAM - CAM for Woodworking Joints
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Torch Height control
By Bobp in forum General ElectronicsReplies: 21Last Post: 09-12-2019, 04:46 PM -
uPVC CNC Corner Cleaner
By StuH in forum Machine DiscussionReplies: 2Last Post: 20-07-2013, 12:09 AM -
1/4" / 6mm edge finder?
By jcb121 in forum Marketplace DiscussionReplies: 0Last Post: 18-03-2013, 02:58 PM -
Driver wiring to my computer for mach3 to control
By AdCNC in forum Motor Drivers & ControllersReplies: 13Last Post: 01-04-2010, 12:27 AM -
Electronic edge finder: how do they work?
By irving2008 in forum Probing, Digitizing & ScaningReplies: 14Last Post: 29-08-2009, 10:25 PM
Bookmarks