Wiring a Corner finder and height control

[D-man]

Oh I see thanks for that. Would the ground be the tool and the plus the edge finder?

sorry here is the link http://www.themakersguide.com/home/p...-edge-finder-2

[Boyan Silyavski]

Most of all depends of your exact BOB. Whats yours? Usually on pin 13 directly if you have pull up resistor there. http://www.autoleveller.co.uk/cnc-probe-guide/

[JAZZCNC]

Oh I see thanks for that. Would the ground be the tool and the plus the edge finder?

Yes but you don't always need the Gnd clip depends if machine/spindle goes to gnd. For safety sake your better using both.

[D-man]

I'm using the uniport

[D-man]

just reading your linksilyavski, is the resistor needed in my application?

[EddyCurrent]

just reading your linksilyavski, is the resistor needed in my application?

No, it says this in the uniport manual;

"Either way you can wire switches between input and ground with no external component needed."

[D-man]

you know, i keep forgetting to read that damn manual! guess i just like testing you guys haha

[JAZZCNC]

Uniport works fine straight from the inputs I used one for 2yrs until it gave up the ghost. My famous Rupert Egg touch probe video was using the uniport.