Hybrid View
-
30-10-2014 #1
-
The Following User Says Thank You to JAZZCNC For This Useful Post:
-
30-10-2014 #2
I'm using the uniport
-
30-10-2014 #3
just reading your linksilyavski, is the resistor needed in my application?
-
30-10-2014 #4
-
30-10-2014 #5
you know, i keep forgetting to read that damn manual! guess i just like testing you guys haha
-
30-10-2014 #6
Uniport works fine straight from the inputs I used one for 2yrs until it gave up the ghost. My famous Rupert Egg touch probe video was using the uniport.
-
01-11-2014 #7
OK guys i got the touch probe working (ish)
The bit touches the ali plate - stops and backs off
comes down again slower - stops
but rather than reset above it drives the tool down!!
for the purpose of the video - "PLEASE NOTE: No innocent tools were hurt in the making of this video. collet is loose and the tool is wounded volunteer" the thud at the end is the escape key being pressed.
http://youtu.be/6pdbWh9RMbc
Thread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
Torch Height control
By Bobp in forum General ElectronicsReplies: 21Last Post: 09-12-2019, 04:46 PM -
uPVC CNC Corner Cleaner
By StuH in forum Machine DiscussionReplies: 2Last Post: 20-07-2013, 12:09 AM -
1/4" / 6mm edge finder?
By jcb121 in forum Marketplace DiscussionReplies: 0Last Post: 18-03-2013, 02:58 PM -
Driver wiring to my computer for mach3 to control
By AdCNC in forum Motor Drivers & ControllersReplies: 13Last Post: 01-04-2010, 12:27 AM -
Electronic edge finder: how do they work?
By irving2008 in forum Probing, Digitizing & ScaningReplies: 14Last Post: 29-08-2009, 10:25 PM
Bookmarks