Fogless Mister Systems

[Boyan Silyavski]

May be you are already aware of these plans, seems quite cheap and easy to build.

I am also contemplating how to do it.

Perhaps the cheapest and least complicated way to do it will be to dedicate small air compressor +the nozzle from the plans above.

Now comes to my mind that instead of fiddling with pressure tanks, connectors and so, it would be best to use the compressor tank itself and half fill it with cooling liquid. So the drain valve connection will feed the cooler line, the air will come from the air line. Both lines will go into the nozzle and mixture will be regulated via needle valve there.


So basically the only modification needed will be fit inlet valve from where the liquid goes in. Though can be done by simply unscrewing the regulator above or the liquid line below and refill, without any modification.