Emco pc mill 55 upgrade

[Craiggillzzr1400zx10r]

Hia again, managed to find time to have a look at the mill again,,,think iv sorted the e stop issue as it was showing a constant emergency mode so i swapped the configuration box over and its cured that so at least now i can get the computer to move the mill in a virtual sense but still no movement on the actual machine,,,what's the next move oh cnc yoda

[JAZZCNC]

Ok so now Mach3 is reset.! . . . Are the Motors Locked.?

Can you post your Mach3 XML file so I can see how you have Mach3 setup. You'll find the profile in Mach3 folder unde the same name as the profile your starting Mach3 up with ie: Machmill and it will end with XML.

Zip it up before posting else forum software won't let you post it.