New Mill losing steps

[EddyCurrent]

When you say mill are you meaning a router type machine ?

Numbers seems to be all over the place.

Is the motor layout like this ?
1 on Z axis
1 on Y axis
2 on X axis (X on one side and A on the other ?)

If they are then X and A should have the same settings for a start because they have to work in harmony, the velocity and acceleration on A are too high.
If the machine can't physically achieve the settings you've put it will loose steps

[lukecnc2012]

[lukecnc2012]

Only one motor on each axis the 4th axis is detachable.so currently of the machine.what sort of feed should be reasonable for this machine currently only running 200 mm pm

[JAZZCNC]

Are you sure it's loosing steps or just not moving the correct amount.? Those numbers for X & Y suggest 2.5mm pitch running 2000 micro steps which would work out 800 Steps per and your not set to that amount so would be some error.?
Similair with Z axis and working on same pitch but with 1000 micro step = 400 steps per again your not quite there.!

Need lot more info to help correctly with setup and what can achieve.

Voltage the drivers are using. (also make and model of drives)
Micro stepping set on drives.
Ballscrew or Lead screw and the pitch. Ie distance traveled for one Revolution.
Units set in Mach Ie: MM or inch

What size motors and frame size Ie Nema 23 or 34.? They look like 34's.!

I see a Laptop in back ground are you using this to run machine via parallel port.?

Give this info and we can help better thou you should be getting much more than you are now without loosing steps.

[lukecnc2012]

Thank you for the reply will update later with more information

[lukecnc2012]

Are you sure it's loosing steps or just not moving the correct amount.? Those numbers for X & Y suggest 2.5mm pitch running 2000 micro steps which would work out 800 Steps per and your not set to that amount so would be some error.?
Similair with Z axis and working on same pitch but with 1000 micro step = 400 steps per again your not quite there.!

Need lot more info to help correctly with setup and what can achieve.

Voltage the drivers are using. (also make and model of drives)
Micro stepping set on drives.
Ballscrew or Lead screw and the pitch. Ie distance traveled for one Revolution.
Units set in Mach Ie: MM or inch

What size motors and frame size Ie Nema 23 or 34.? They look like 34's.!

I see a Laptop in back ground are you using this to run machine via parallel port.?

Give this info and we can help better thou you should be getting much more than you are now without loosing steps.

Hi.think the motors are nema 34 there 8.2nm.
I'm using the laptop to run the machine through port.
its set to running in mm.
If possible could you guide me in the direction to find the rest of the information as im not sure where to find this information.
would be amazing to having it running as it should so your help is much appreciated

[lukecnc2012]

[lukecnc2012]

[lukecnc2012]

[lukecnc2012]