Thread: Cnc 3040t
Threaded View
-
14-11-2014 #6
Last Activity: 19-01-2024
Yes that's how you would do it when using Analog spindle axis but you still need to set in combination with the pulley Min/max speed to do it properly and get away from spindle over or under speed error messages.
Originally Posted by EddyCurrent
On my system the 0-10 volts goes to an inverter and that is configured accordingly so that 10v = top speed.
To get the S command working so it was 1:1 relationship I played about with the numbers here in Mach3
PWM is slightly differant and done with Pulley and Modbus settings but still after same result of 10v output for maximum spindle speed.
-
The Following User Says Thank You to JAZZCNC For This Useful Post:
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
SOFTWARE NEEDED TO RUN My CNC 3040T
By owen3371 in forum Machine Control SoftwareReplies: 5Last Post: 22-02-2020, 03:38 AM -
Chinese 3040T Arrives
By Gregor in forum Workshop & EquipmentReplies: 114Last Post: 11-07-2014, 05:55 PM
Bookmarks