Small metal airsoft part

[JAZZCNC]

That looks great, ill PM my address to you now.

How much do you want for it? Its only fair that i pay for your time and effort.

Well I'm getting low on Guiness but I'm also getting tubby so we'll just call it a 6 pack not 12. . .

Edit: Not had PM just in case you tried sending and hasn't worked.?

[JAZZCNC]

For anybody who wondered how or what went into doing it then here is the simulation. Never thought to do video.!!
Not much too it really 7 operations with 4 tools. Total machine time with tool changes and filp 16mins and 6 tool simulation time 11mins.

OP 1 & 2 clearence with 6mm endmill.
OP 3 holes with 2mm drill
OP 4 & 5 Ramp & hole pocket with 2mm ballnose used to clean up holes.
OP 6 profile 4mm endmill

OP 7 flip and 0,35mm surface to break loose with 4mm tool.

[GEOFFREY]

Jazz, its dead easy when you know how - that's the hard bit. Really good of you. G.

[JAZZCNC]

Jazz, its dead easy when you know how - that's the hard bit. Really good of you. G.

To be honest Geoffrey I like the change from doing boring run if the mill Z axis and gantry parts etc i'm always doing. Small parts I find rewarding and challenging because they are hard to hold with very little room for error. Worst bit is tool changes can take longer than the Op's it's here where a ATC would be nice. . .Lol