Small metal airsoft part

[TheGrover]

Ok the part model is now revised, see the files attached to this post.

Changes from the Mk1 to the Mk2:

• area beneath the lever arm removed due to a clash with part of the hop unit (the part that this arm is fixed within)
• Nub effector (lowest part) raised by 1mm to move the "Sweet spot" of adjustment closer to the centre of adjustment, giving a greater range of adjustability
• Pin Hole enlarged slightly to make installation easier and movement less restricted (also rounded the internal face as sketchup can't do curves properly)
• Lever arm reduced in size to correct a fundamental error made with the Mk1 (my bad :P)

All these corrections should make the part just slip in nicely and work a dream.

If anyone needs any help with the part, or another file type creating, just PM me on here