8x4 router build. Steel base & Aluminium gantry gantry

[JAZZCNC]

i like the sound of that! Do they require much setting up and wiring like steppers do? If you like I can get them, you can do your review and then send them back all wired up ready to go haha

If your talking about servo's then yes and no. Yes there's still signal wires from drives to controller but from drives to servos then you'll buy cables ready made up.
To be honest derek if your not familiar with servos and PID tuning which can be tricky at times then you will be better sticking with steppers as they are simple easy and just has accurate if sized and run within there parameters.
Yes modern servos and software are making it easier to tune them but compared to steppers there is still much more to them and more to wrong.!!

And No before you ask.!! . . . Lol . . . Far far too busy.

[firetrappe]

BUT just for clarity then the latest IP-M Beta Firmware now does slaved motors, all be it in a cut down way to the IP-S. (I haven't tried it yet so can't vouch for how well but I will and report)
The way the IP-S handles slaved motors is different to typical way slaved motors are done with other controllers in that when it hits the switches it's got an option to measure the difference between each switch contact then applie an offset movement to one motor to square the gantry. That said with servo's you'd home using the encoder index which is much more accurate than switches but it works well for steppers without encoders.
Other controllers like the ESS require you to manually adjust the switches to square the gantry.!

Good to hear that the IP-M will support slaved motors soon. If that had been the case 12 months ago then i'd have jumped on it rather than the PMDX/ESS combo.

For reference though, the last few plugin versions for the ESS (ESSv10r2d1d being the latest) support misaligned home switches. You can now apply an offset in the 'advanced homing config' dialog rather than having to physically adjust the switches.

[Boyan Silyavski]

BUT just for clarity then the latest IP-M Beta Firmware now does slaved motors, all be it in a cut down way to the IP-S. (I haven't tried it yet so can't vouch for how well but I will and report

Now that's great news.

[D-man]

Well, I've managed to get a good start on the machine over the past couple days. This thing is solid!

[Boyan Silyavski]

What a beauty. My heart warms looking at big steel structures