8x4 router build. Steel base & Aluminium gantry gantry

[JAZZCNC]

i like the sound of that! Do they require much setting up and wiring like steppers do? If you like I can get them, you can do your review and then send them back all wired up ready to go haha

If your talking about servo's then yes and no. Yes there's still signal wires from drives to controller but from drives to servos then you'll buy cables ready made up.
To be honest derek if your not familiar with servos and PID tuning which can be tricky at times then you will be better sticking with steppers as they are simple easy and just has accurate if sized and run within there parameters.
Yes modern servos and software are making it easier to tune them but compared to steppers there is still much more to them and more to wrong.!!

And No before you ask.!! . . . Lol . . . Far far too busy.