. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 28-11-2014 #17
    vargai's Avatar
    Lives in Pázmánd, Hungary.
    vargai
    Last Activity: 10-09-2015 Has been a member for 9-10 years. Has a total post count of 90. Received thanks 2 times, giving thanks to others 10 times.
    Quote Originally Posted by Sven View Post
    I have the second set up in your diagram, with the motor in the middle. It is impossible to get enough tension in the belt without putting big loads in the spindle bearings.
    I added a guide to push the middle section of the belt above the motor to reduce floppiness. still not good.
    Let me know about the data bearing type, size, belt type, size and experienced phenomenon
    angular bearing on drive side it can bear more load than single row
    20/10 ball screw with Dia 15 machined end -bearing can hold let's say max 1 Tons here
    Last edited by vargai; 28-11-2014 at 11:16 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. BUILD LOG: 8x4 router build. Steel base & Aluminium gantry gantry
    By D-man in forum DIY Router Build Logs
    Replies: 57
    Last Post: 13-12-2019, 10:43 AM
  2. BUILD LOG: A sufficiently strong machine
    By Jonathan in forum DIY Router Build Logs
    Replies: 42
    Last Post: 29-03-2014, 10:40 PM
  3. Accurate Tape Measure?
    By Tenson in forum Tool & Tooling Technology
    Replies: 19
    Last Post: 26-05-2012, 04:41 PM
  4. NEW MEMBER: Strong 1212DS - any good?
    By MrWiz73 in forum New Member Introductions
    Replies: 0
    Last Post: 29-03-2011, 11:13 AM
  5. Bit OT - accurate timing
    By m_c in forum General Electronics
    Replies: 3
    Last Post: 18-05-2009, 01:16 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules