Thread: Halifax 10" lathe
Threaded View
-
06-12-2014 #11
Ross just re-reading and see you say rear "bearing slides" I cannot see how pre-load can be done without this bearing sliding, I cannot get this off even with puller as only place to get puller is outer race so don't want to put to much force on it. I'm thinking using a press but this would be forcing against plastic pulley with the force being applied on the damaged (threaded) end of spindle can you see any problems as I don't want to damage pulley.
just read thro your repair post. What happened to the chap (bogstandard) you was communicating with?Last edited by i lunn; 06-12-2014 at 02:11 PM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
NEW MEMBER: Hello from Halifax !!
By malzyk in forum New Member IntroductionsReplies: 0Last Post: 07-09-2013, 02:26 PM -
WANTED: 5" / 125mm Lathe chuck
By Jonathan in forum Items WantedReplies: 2Last Post: 21-02-2012, 01:22 AM -
FOR SALE: Southbend 13" lathe
By Swarfing in forum Items For SaleReplies: 5Last Post: 27-11-2011, 10:54 AM -
Repairing Atlas 10" lathe
By Ross77 in forum Lathes, Lathe Rebuilding & ConversionsReplies: 57Last Post: 18-07-2010, 02:10 AM -
FOR SALE: My old Southbend 415 9" lathe is now on ebay
By BillTodd in forum Items For SaleReplies: 0Last Post: 04-09-2009, 09:25 PM
Bookmarks