Thread: Use of epoxy for levelling
Threaded View
-
26-12-2014 #6
Neale, your readings of the resin accuracy are interesting. Seves thou is 7*0.0254=0.18mm which is a bit more than I'd expect (though by no means a showstopper). Did you see the readings for the expoxy 'straightness' I took in my build log?
Towards the end of that graph there is a large negative deviation. It turns out this was not actually the case - the bearing block was rubbing on the aluminium epoxy barrier which pushed it out of line for the last 100mm or so. Either way, the deviation is very small...
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Self levelling epoxy resin
By flanagaj in forum Gantry/Router Machines & BuildingReplies: 5Last Post: 21-11-2020, 01:47 AM -
Epoxy granite or mineral casting
By mike mcdermid in forum Gantry/Router Machines & BuildingReplies: 46Last Post: 20-02-2014, 06:21 PM -
Epoxy Granite Molds?
By gavztheouch in forum Moulding MachinesReplies: 8Last Post: 18-02-2014, 07:28 PM -
Epoxy pouring advice
By cncJim in forum General DiscussionReplies: 12Last Post: 18-02-2014, 05:25 PM -
Epoxy cast plastic injection tools
By gavztheouch in forum Moulding MachinesReplies: 0Last Post: 27-01-2014, 11:33 PM
Bookmarks