UCCNC and Rodocutter X4 Problems

[RusticRusty]

Here is the setup of the Z axis. Is there anyway I can slow just the Z axis down so it only runs at 20% and the rest to run at 100%? Sorry I dont know much about the settings to change them at the moment.

Here is a pic of the machine before I wired it up if it helps.

[EddyCurrent]

In the photo you showed in your first post, what material are you cutting and what cutter did you use ?

[RusticRusty]

In the photo you showed in your first post, what material are you cutting and what cutter did you use ?

5.5mm ply and using a 3mm end mill.