Ar last!!! Started my Gantry 3-Axis CNC Build

[routercnc]

Thanks Neil - I'll replace the Vax at some stage after I've used the machine a bit more. Right now stuck with having to do house diy prepping for my daughter's wedding. After that's done then back to CNC to finally do the following:

1. Get NPN Homing switches working..
2. Wire VFD into safety switch system. I've read somewhere that you should'nt cut the power to the VFD by switching the mains off but by send a stop signal to the VFD. Currently using Modbus-type communication plugin on Hunyang VFD for stop, start and speed control.

My wife was watching the Royal wedding recently and there was a comparison made to the dress worn on the previous Royal wedding. She said the other dress was much better and asked my opinion. ‘They are all great- just variations on a theme’. Apparently this was not the right answer.


2) Yes, send stop signal to the VFD. My understanding is that the spindle will spool down and the back EMF could damage it if power is removed. You can use a delay timer if you really want to cut power after a second or two. But for home DIY machines this is not commonly done.