Threaded View
-
12-12-2014 #1
Dear forum.
I have a diy gantry type router running with NEMA23 3ph steppers. 3,1Nm
Y-axis 2 motors for gantry D16 x 10mm Lead ballscrew. Gantry running on THK 16mm rails. Estimated 40kg.
X-axis 1 Motor for ?? x 40mm Lead ballscrew (IAI actuator) Estimated: 8kg
Z-axis on a THK KR33 actuator 6mm ballscrew. Estimated 3 kg
So I get fair good Rapids, but the system is tending to resonate espacially the Z-axis.
I was looking to convert to DC servos, at a max. of 300 USD pr. motor set that's including "everything needed"
My goal was to find a NEMA23 motor and direct driven to the 10mm lead ballscrew as that would be an easy replacement.
I did a calculation (MotorCalcs.xls from this site) for the torque pr. motor required and for the Gantry it's 0,52Nm (Rapids) and 0,21Nm (Cutting)
Initially i looked at at 2 pce DC Brushless 180W 0,57Nm Rated (1,71Nm Peak) servomotors for the double Y-axis, gantry drives.
Make:Leadshine Model: BLM57180
I have zero experience selecting a servo, and looked at DC-brushed, brushless and AC-servo. So what to select ?
Best Regards, Bo Andersen.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Best type of shed.
By Philly in forum General DiscussionReplies: 14Last Post: 03-11-2018, 08:17 PM -
Which Type of Limit Switch
By manofgresley in forum General ElectronicsReplies: 52Last Post: 29-07-2014, 03:43 PM -
Hobbymat BFE65 Conversion - Gearing my Steppers?
By jamezwarner in forum Gantry/Router Machines & BuildingReplies: 1Last Post: 06-09-2011, 06:08 PM -
What type of resistor?
By Smiler in forum General ElectronicsReplies: 4Last Post: 05-12-2008, 10:04 PM
Bookmarks