Simple Machine (help and advice needed)

[JAZZCNC]

That design can't work.! How you going to connect to gantry.?

[Gregor]

Hi Jazz
It was went to fit like this but looking at it it looks stupid .

[JAZZCNC]

Hi Jazz
It was went to fit like this but looking at it it looks stupid .

Bad idea for few reasons really. The bed isn't supported at the edges and the L brackets are too flimsy.
It will work if you Support the edges and run a piece across to each gantry side under the supports with thicker drop plates.

[EddyCurrent]

What about for the bearings you bolt a piece of say 20mm aluminium plate on using 4 cap head hex screws (I've shown bolts) in counterbored holes, then you slide the carriage along to each end of the rail in turn, so you can fasten the plate onto the gantry using 2 bolts (or maybe 4) inserted from below. Or if you put the 2 bolts in first there's probably enough room to tighten them above the rail.

[dazza]

oops edit I just looked at the previous pages and see you covered it. I would definitely stick with the screws on the outside compared to the last drawing.

[njhussey]

From your sketch it looks like the belt and pulleys are on the inside of the 50x50 end piece? How the heck are you going to get at them to fit/tighten/adjust etc? I'm not sure about the single carriage for the X &Y axis either, are they going to be man enough for the cuting forces generated?

[EddyCurrent]

Neil, I think they are the long type bearings but you are right, four of the regular ones (2 each side) would be a lot better.